LOADRITE SPRINT OPERATORS MANUAL
19
To access the Setup options:
1. Press .
2. Use to scroll to Setup.
3. Press to select.
4. The Loadrite prompts you to enter an access code. For special
functions, key in your security code and press
.
Clock Setting (Clock)
Clock Setting editing is an optional function that is selected during
installation. Once enabled, you have access to change the Loadrite internal
clock (date/time) setting.
To set the time and date – refer to page 32.
Changing Scale Number (Scale#)
This function enables different load bearing implements to be used by the
vehicle. It is available only if the multiple scale feature has been enabled
during installation. For example, bucket or forks. Each should be assigned
a number. Once enabled, the operator needs to select the correct scale for
the attached implement.
To change the Scale
1. Press . The time is displayed.
2. Use to scroll to Scale#.
3. Press to select.
4. Use to scroll to the desired scale number, then press .
It is important to check zero before continuing (page 13).
To Next Page
Loading...
