Start-up
Connecting to the Mains Supply
Plug the mains plug (page 6) into a mains socket 220-240 V/50-60 Hz.
Switching On/Off
Set the remote control for BluTechVision Interactive
operation by briefly pressing the button DVD.
Your BluTechVision Interactive switches on. If you have con-
nected a Loewe TV set (from L271x) via HDMI, then this will
switch on as well. Otherwise, switch your TV set on and set the
respective AV programme slot.
➠ For your TV set you may have to adjust operation of BluTech-
Vision Interactive to suit the AV socket used (look under e.g.
"Operating other devices" in the respective operating instruc-
tions for your TV set.
As soon as BluTechVision Interactive is ready to go, the green
Operating Display (page 6) lights up.
To switch the device off, press the On/Off button on the
BluTechVision Interactive or on the remote control Assist
again.
Digital Link HD
With the Digital Link HD, the Loewe TV sets and other TV sets supporting CEC
default transmit the signals of the remote control via HDMI connection from the
TV set to the BluTechVision Interactive.
➠ The TV set needs to be switched on.
On the TV set, select the AV programme slot for HDMI.
As long as HDMI is selected as the programme slot, most TV remote control
commands (ASSIST in TV mode) will be passed on to the connected HDMI unit.
Volume, sound on/off, sound adjustment and TV aspect ratio however, still affect
operation of the TV set. The AUDIO commands (ASSIST in AUDIO mode) are not
passed on by the TV.
By pressing the TV button for a long time, you can switch between
HDMI and TV operation. Pressing the TV button briefly switches
back to TV mode.
With the TV button (press briefly), in TV operation you switch
back to the last station watched and terminate the device
control.
➠ It is possible that your Loewe TV set may need a software
update. Please contact your specialist retailer.
Digital Link HD (HDMI CEC)
With Digital Link HD, Loewe TV sets (from Mainframe L271x, Software V9.2) pass
the signals from the remote control via the HDMI connection from the Loewe TV set
to compatible additional devices, such as BluTechVision Interactive. Digital Link
HD makes sense if you want to set up BluTechVision Interactive in a concealed
place and all the devices are to be controlled via the Loewe TV set.
First of all, adjust the HDMI CEC function for the Assist
remote control as described on page 12 to Code 22 on the
required device button (e.g. DVD).
Then carry out the allocation of the Digital Link HD function to
the HDMI interface of the TV set used by pressing the button
set above (e.g. DVD) for 5 sec.
A selection menu will appear.
OK
END
OK
Select HDMI device for key
AudioVision
No device
Adopt
Hint
Here you select the device which you want to switch over your remote
control to with the key. After confirming the selection with OK all
remote control commands are passed on to the selected device via the TV set
in future when you press this key.
AUDIO
AUDIO
Select the desired equipment
(e.g. BluTechVision Interactive).
Confirm OK.
Now the signals from the Assist remote control are passed on
by the Loewe TV set to BluTechVision Interactive if the
respective device button (e.g. DVD) was pressed beforehand.
➠ It is possible that your Loewe TV set may need a software
update. Please contact your specialist retailer.
13 -
To Next Page
Loading...