Loewe BluTechVision Interactive - Network Menu

Start-up
Network Menu
Your BluTechVision Interactive can be connected to a home network (LAN) with
internet connection via the LAN connection on the back (page 10). This allows
you to use the BD-LIVE service which provides you with optional information from
the manufacturer of the Blu-Ray disc.
You can carry out the settings required for your home network in the NETWORK
Menu.
Connection Setting
Connection Status
BD-LIVE connection
Permitted
Partially permitted
Prohibited
DISPLAY
LANGUAGE
AUDIO
LOCK
NETWORK
OTHERS
Setting the network connection automatically
If you have DHCP server in your home network (e.g. a DSL Router), your BluTechVision
Interactive can carry out all network parameter settings automatically.
Call up the Setup menu.
Select option NETWORK.
  Select option Connection Setting.
Confirm OK.
The menu Connection Setting appears.
.. .
.. .
.. .
.. .
.. .
OK Cancel
IP Mode
Dynamic Static
Auto Manual
IP Address
Subnet Mask
Gateway
DNS Server
Primary
Secondary
CONNECTION SETTING
Confirm OK.
Your BluTechVision Interactive now tries to create a
connection to the internet router in your home network. It
uses the above standard settings (IP Mode: Dynamic, DNS
Server: Auto) for the automatic search for the network
parameters.
If a dynamic IP Address has been allocated, a corresponding
message appears.
Setting Wired Dynamic IP completed.
For the connection test, press 'Test'.
OK
CONNECTION SETTING
Test
 Select Test option in order to carry out a connection test.
Confirm OK.
0:e0:91:9c:c3:d0
192.168.0.30
255.255.0.0
192.168.0.5
192.168.0.5
OK
Network is connected.
Wired Network
MAC :
IP :
Subnet Mask :
Gateway :
DNS:
Internet : Success
Local area network : Success
CONNECTION STATUS
RetrySetup
If the connection test is successful a corresponding message
appears in the Connection Status Menu.
OK Close menu
Retry Repeat
Open Setup menu Connection Settings
Connection Status Menu
You can have the current network parameters displayed.
Call up the Setup menu.
Select option NETWORK.
  Select the option Connection Status.
Confirm OK.
The Connection Status Menu appears.
- 20