Reference 55-85
User manual
79
Cinema Surround
Cinema Surround is a Virtualizer mode that offers the possibility to
create an virtual surround sound by means of the built-in TV speakers.
Selecting the Surround mode
The choice is available for sound component - TV speakers. All other
audio components do not support this mode.
Adjustable in the System settings under Connections טSound
components.
The selection of surround modes is available when sound mode
܃or܃ is used.
Adjustable in the System settings under Sound טSound mode
or in the current TV programme via the function list (see chapter
TV, section Function list).
HOME: Call Home view.
Select System settings,
OK call System settings.
Select Sound,
go to next column.
Select Surround Mode,
OKcall.
Select the desired mode.
Explanation of the setting options:
Cinema
Surround
For the Cinema Surround mode an advanced
Virtualizer technology is used that is developed by
Loewe. This one improves speech intelligibility while
simultaneously widening the 3D sound.
Default setting ex factory.
Dolby Virtual
Dolby Virtual simulates the hearing impression of
a 5.1 surround sound system via the built-in TV
speakers.
...
Surround
Mode
Cinema
Surround
Dolby
Virtual
“Cinema Surround” gives the front speakers additional
virtual room depth when playing in the listening
modes (4) and (5).
System settings
Sound
Explanations of the sound settings (continued):
more ...
Loudspeaker/
Headphone
sound
For analogue stations:
Selection options for Mono/ Stereo or Sound 1 or
Sound 2 for bilingual programmes, separately for
the loudspeakers and the headphones.
Auto volume
The volume may vary when receiving stations with
different standards, when switching from station to
station or during commercials.
You can reduce these differences in volume by
selecting auto volume on. For music and live broad-
casts you get a better sound spectrum with auto
volume off.
Maximum
volume
You can limit the volume adjustment of the loud-
speakers. This prevents selecting a volume which
is too loud.
Maximum
switch on
volume
Set the sound level to be heard after switching on the
TV set with the mains switch or after a power failure.
When switching on the TV set in standby mode, the
volume last used is retained unless it was above this
switch-on level. Otherwise it is limited by this.
Balance
Set stereo balance so that the volume impression is
identical on the left and right.
To Next Page
Loading...
Need help?
General