Loewe Reference 85 User Manual

Reference 55-85
User manual
94
Software update via Antenna
A software update via antenna is only available for stations of the
Freeview DVB-T platform in the UK and Ireland.
Calling Software update
HOME: Call Home view.
 Mark System settings,
OK call System settings.
 Mark Control,
 go to next column.
 Mark Software,
 go to next column.
 Mark Software update,
 go to next column.
 Mark Via Antenna,
 call Software update.
You will see a message on the screen regarding
data protection.
 Proceed.
The TV set searches for a new software package.
If a new software version is available after the search, an
on-screen message appears (see below).
If no new software package was found in the search:
BACK: End of wizard.
New software package found
 Proceed starts loading of the new software.
Or:
BACK: End of wizard.
The update will then not be carried out.
... Via antenna
Current software: 1.1.11.0
For loading a new software, it is mandatory to have the antenna cable attached
to the TV. Start search pressing the key .
SOFTWARE UPDATE WIZARD - Current software
Proceed with Cancel with
...
Proceed withProceed with End withEnd with
Via antenna
New software
A new software version was found.
New software: V1.1.14.0 (Current software: V1.1.11.0)
If you now wish to load the new software, press the button. Otherwise
close with the button.
Ensure that the TV set is not switched off at the mains while it is loading the
data.
A new software version was found.
New software: V1.1.14.0 (Current software: V1.1.11.0)
If you now wish to load the new software, press the button. Otherwise
close with the button.
Ensure that the TV set is not switched off at the mains while it is loading the
data.
Load new software package
The software is downloaded in several steps. The total
downloading and programming process can take up to
approx. 50 minutes in total.
Please do not switch off your TV set with the mains
switch during the entire loading and programming
process.
After the update, the TV set is automatically powered
off and on again.
Depending on the software loaded, it is possible that
the device may not turn off automatically after the
update. Therefore, please supervise the update
process.
When the TV set is switched on again, a message is
displayed.
BACK:End of wizard.
60%
...
-NSD3GDKN@CHMF@MCOQNFQ@LLHMFOQNBDRRB@MS@JDTOSN@OOQNWLHMTSDR
in total. Please do not switch off your TV set at the mains during this time.
Note: Depending on the loaded software, it is possible that the device cannot
automatically switch off after the update. Therefore, please monitor
the update process.
-NSD3GDKN@CHMF@MCOQNFQ@LLHMFOQNBDRRB@MS@JDTOSN@OOQNWLHMTSDR
in total. Please do not switch off your TV set at the mains during this time.
Note: Depending on the loaded software, it is possible that the device cannot
automatically switch off after the update. Therefore, please monitor
the update process.
Updating software
The "V1.1.14.0" software is currently being programmed, please wait ...
Via antenna
The software was successfully updated.
Hint
Finish wizard with

System settings
Control

Loewe Reference 85 Specifications

General

Brand	Loewe
Model	Reference 85
Category	TV
Language	English