45
B751
Figur 1.
5M
5M
5M
15M
USE
Hard knots may cause deviations in the outcome
of the sawing.
BEFORE EACH USE:
Check that
• the operator is wearing the prescribed personal
protective equipment
• the maintenance prescribed has been carried
out
• the bandsaw blade is stationary while the
engine is idling
• the machine has been erected so that it is stable
and the rail is supported along its entire length
• the saw carriage’s anti-tip wheels and the rail’s
end stops are in place
• all components on the band sawmill are secure
and serviceable
• all the safety equipment on the machine is in
place and in proper working order
• the bandsaw blade is properly installed and runs
freely in the right direction.
Before each kerf:
Check that
• there are no other persons or pets within the
danger zone of the machine
• there are no obstacles at the work site that
could cause a trip hazard or be a nuisance
• the bandsaw blade runs clear of the log
supports and log clamp
• the rail is clear of debris, dirt, etc.
• the workpiece is secured in place
• the adjustable saw blade guard is set correctly
to accommodate the maximum width of the
workpiece.
When in use:
WARNING! Risk of burn injuries. The engine
and its silencer become very hot during
operation, and remain hot for a while after the
engine has been shut down. This also applies
when the engine is idling.
WARNING! Fire hazard. Petrol and petrol
vapours are highly flammable. Bear in mind the
fire, explosion and inhalation hazards involved.
The engine must have been shut down
and allowed to cool for 10 min before fuel
is added.
Always shut down the combustion engine
when leaving the operator station, even you
are only away for a few moments to deal with
sawn timber or carry out maintenance.
To Next Page
Loading...
