Logosol B751 - Chip Collection

46
STORAGE
The bandsaw blade must be removed from the
machine and stored out of reach of children and
other persons, even if the machine will not be used
for just a short time.
When stored for longer periods the following
applies:
- the fuel tank and coolant reservoir are emptied,
- the bandsaw blade is removed from the machine,
- the fuel tap is closed,
- the saw carriage is locked in position.
Store the band sawmill in a place that is not
accessible to children or other persons, preferably
in a locked room.
Blade tension must be released at the end of
each completed shift to reduce wear on the
bandsaw blades.
MAINTENANCE
WARNING! Risk of serious injury.
Turn the ignition switch to OFF and close
the fuel valve before servicing or performing
maintenance on the machine.
WARNING! Risk of burn injuries. The engine
and its silencer become very hot during
operation, and remain hot after the engine has
been stopped.
Allow the engine and silencer to cool down
before servicing or performing maintenance
on the machine.
MOVING THE BAND SAWMILL
WARNING! Risk of entrapment.
When lifting and moving machine parts, keep
persons and animals outside the 5 m danger
zone around the machine. Secure the load
during transport.
The saw carriage and rail component must not
be lifted or transported while assembled, but
must be transported separately.
Lifting the saw carriage: Remove the anti-tip
wheels of the saw carriage, one on either side,
and then use safe lifting equipment to lift the saw
carriage using the lifting eyes right at the top of it.
Weight, see Technical data.
Lifting of rail component: Use pallet forks or a
fork lift to lift the rail from below. Place a protective
layer of wood material on the forks before lifting.
Make sure that the rail component is well balanced
and secure the load to the pallet fork before
transporting it. Weight, see Technical data.
REFUELLING
WARNING! Risk of burn injuries. Petrol is
a highly flammable liquid.
Wait until the machine’s engine has cooled
down before refuelling it. Turn the ignition
switch to OFF and close the fuel valve.
Refuelling: refuel the engine with the saw head in its
bottom position and the saw carriage in its locked
position at either end of the rail. Use a funnel and
try your best to avoid spilling fuel.
The sawmill can be run without chip extraction
if it is used outdoors.
Make sure that the sawdust collecting
at the machine is removed at regular
intervals using a spade, for example.
A capacity of at least 800m
3
/h is required
if chip extraction is connected.
Extraction hose: Any extraction hose
connected to the sawmill must be
fitted with a coil that can be earthed.
USE
CHIP COLLECTION