47
B751
STARTING
1. Open the fuel valve by moving the slide control
to the right to the "ON" position.
2. To start a cold engine, set the choke to closed
position (lever to the left). To start a warm engine,
leave the choke in open position (lever to the right).
3. Set the ignition key to “ON”.
4. Gently pull the starter handle until you feel
resistance, then pull firmly. Carefully return the
starter handle.
5. Open the throttle by squeezing the throttle
control all the way to the end position. This will
increase the speed of the combustion engine to its
operating range, and the bandsaw blade will start.
6. If the choke is in closed position, gradually move
the control to open position as the engine warms up.
STOPPING
The saw blade is stopped by releasing the throttle
control on the push handle. The bandsaw blade
is then decelerated to a standstill, and the engine
drops to idling speed. Then shut down the engine
by turning the ignition key to “OFF” and then
closing the fuel valve.
STARTING AND STOPPING
To Next Page
Loading...
