Logosol F2+ - Technical Data; Description of Machine

6
• The aluminium components are anodized and
completely rustproof. The outer surface is as
wear-resistant as tempered steel, has a low
friction coefcient and is easy to keep free of
resin and sawdust.
• Adjustable feet make it easy to compensate for
uneven surfaces.
• Clear scales show the height of the log beds.
Extra measuring rods are available as accessories
to show the set sawing height.
• The crank axle runs through maintenance-free
bronze bearings that do not wear out.
• The slide rails use low-friction plastic that has a
long lifetime thanks to the ne surface of the
aluminium components.
• The settings for sawing parallel to the grain of
conical logs are quick and simple to set. (The log
beds should be set at different heights for more
than half of the cuts to get an acceptable yield.)
• There are many accessories available for the
Logosol F2+.
Maintenance
The Logosol F2+ should be kept clean, and all plastic
parts should be lubricated with Logosol’s lubricant
(7500-001-5050) or silicone lubricant (7500- 001-
5067). Regularly check the condition of the lifting
lines.
The tempered ratchet bar is only lightly protected
against rust and should be kept coated with a thin
layer of Supero (9999-000-5115) to prevent rust.
Service
The sawmill must be inspected regularly and maintained
as needed.
Only carry out the maintenance and repairs specied
in the manual. Other repairs must be carried out by
Logosol or by authorized Logosol dealers.
Do not make any alterations to the construction of
the sawmill as this can increase the risk of accidents.
After service, the sawmill should be restored to its
original condition. Logosol accepts no liability for
damage that occurs while working on an improperly
modied machine.
DESCRIPTION OF MACHINE
Length: 4.0 m
Width: 0.92 m
Height: 1.0 m
Log loading height: 0.6 m
Weight: 65 kg
Weight with carriage for chainsaw: 68 kg
Max. recommended log diameter: 0.7 m
Min. log length in standard
conguration: 2.4 m
Max. log length in standard
conguration: 3.7 m
TECHNICAL DATA