LONCIN LC3000i - Generator; Ignition Coil;Recoil Starter

SECTION 4. DISASSEMBLY AND SERVICE
4-4-2 Cylinder Head / Valves
a. DISASSEMBLY/ REASSEMBLY
CYLINDER HEAD
CYLINDER
HEAD GASKET
CRANKCASE
CYLINDER HEAD BOLT
M8×60(4)
REMOVAL/ INSTALLATION:
Loosen and tighten the bolts in a
crisscross pattern.
Torque:32-35 N·m
FILTER SCREEN
CAP,BREATHER
CHAMBER
SHROUD
COMPONENT
CYLINDER
HEAD COVER
BREATHER TUBE
REASSEMBLY:
Before installation, remove carbon
deposits from the combustion chamber
and inspect the valve seats’ tightness.
Measure the compression of the
cylinder head after reassembly.
REMOVAL/ INSTALLATION:
Connect one end to cylinder
head cover, the other end to
breather
chamber cap’s
vertical-up vent.
REMOVAL/ INSTALLATION:
adjust or replace deformed
or non-completely-sealed
valves.
Assembly: the dirty
ones are required to
be cleaned timely.
- 29 -