Need help?Do you have a question about the LORCH MicorStick 180 ControlPro and is the answer not in the manual?
Explains the meaning of symbols used within the operation manual for safety and guidance.
Details the meaning of symbols found directly on the welding machine itself.
Details how to properly attach the transportation belt to the welding machine.
Explains the correct procedure for connecting the ground cable for safe and effective welding.
Guides the user on connecting the machine to the mains power supply, including safety warnings.
Provides guidance on selecting and using mains extension cables safely and effectively.
Details the setup and connection for performing electrode welding (MMA).
Describes the setup and connection requirements for TIG welding.
Describes the behavior of the fault LED and its meaning for system status.
Indicates the status of the remote control connection and its operation.
Explains the VRD LED's function indicating voltage reduction status.
Details the operation of the main control knob for setting current and navigating menus.
Explains the LEDs that indicate the selected welding process (CEL, MMA, TIG).
Shows how the pulsing function is indicated on the control panel.
Details the steps for setting up and executing electrode welding, including arc ignition.
Explains how to perform a master reset, returning all settings to default values.
Lists common error codes, their causes, and recommended actions for troubleshooting.
Lists essential points to check regularly for damage to ensure proper machine operation.
To Next Page
General