Declaration of conformity
909.4119.9-02 - 41 -07.19
22 Maintenance and repair
Please observe the current safety
and accident prevention regulations
during all maintenance and repair
work.
The machine requires a minimum of care and
maintenance. Only a few items need to be
checked to ensure trouble-free long-term opera-
tion.
22.1 Check regularly
Check the following points for damage before
starting up the welding machine:
– Mains plug and cable
– Welding torch and connections
– Ground cable and connection
– Keyboard membrane and control panel
Blow the welding machine out once or twice a
year.
To do this, switch the device and disconnect
the mains plug.
Using dry compressed air, blow the welding
machine out from the front through the venti-
lation slots. Leave the housing closed.
Never blow the compressed air through
the ventilation holes on the rear side of
the machine. The fan is located there
and the compressed air would make
it turn so quickly that bearing damage
may result.
23 Disposal
Only for EU countries.
Do not dispose of electric tools togeth-
er with household waste material!
In observance of European Directive 2012/19/
EU on waste, electrical and electronic equip-
ment and its implementation in accordance with
national law, electric tools that have reached
the end of their service life must be collected
separately and returned to an environmentally
compatible recycling facility.
24 Service
Lorch Schweißtechnik GmbH
Im Anwänder 24 - 26
71547 Auenwald
Germany
Tel. +49 7191 503-0
Fax +49 7191 503-199
Lorch download portal:
https://www.lorch.eu/service/downloads/
You can nd more technical documentation
about your product here.
25 Declaration of conformity
We hereby declare that this product was manu-
factured in conformance with the following
standards or ocial documents: EN 60974-
1:2018, EN 60974-3:2017, EN 60974-10:2018 CL.A
in conformance with the guidelines 2014/35/EU,
2014/30/EU, 2011/65/EU.
2018
Wolfgang Grüb
Managing Director
Lorch Schweisstechnik GmbH
To Next Page
Loading...
General