Basic Setup4
A. Ensure Device ID is selected.
B. Tap to scan the QR code on the back of your recorder using the camera on your mobile
device.
C. Ensure the Client Port reads 35000.
D. Enter the username (default: admin).
E. Enter the password (default: 00000000).
F. Tap Save.
5. Enter a new, secure 8-15 character password. This password will be used to connect to your
system from now on.
6. Your cameras will appear on the Live screen of the app. Tap the play button (
) to stream
live video on channels that are in sleep mode.
NOTE
If you do not see video from one or more cameras, ensure you have removed the PLEASE REMOVE label
from the Power Pack. If the issue persists, see 19 Troubleshooting, page 82.
4.4 STEP 4: Installing the Cameras
4.4.1 Installation Tips
Follow the tips below for more accurate motion detection and to optimize battery life:
• See images below for ideal setup. It is recommended to place your camera at least 7ft (2.1m)
above the ground and angle it slightly downward toward the monitoring area, excluding any
busy areas (e.g., sidewalks or roadways).
• Ensure the camera image is free of obstructions (i.e., tree branches).
#LX400109; r. 5.0/56381/56402; en-US 9
To Next Page
Loading...
Need help?
General