Basic Setup4
• Position the camera no more than 20ft (6.1m) away from the area you wish to monitor.
• It is recommended that you customize motion settings for each camera on your system. See
4.4.3 Optimizing Motion Detection, page 13 for full details.
• For best performance, position the camera so that objects of interest will move from side-to-
side across the camera image, rather than moving towards or away from the camera.
• Install the camera within range of the wireless receiver (noted in the camera’s specifications).
• This camera is weather resistant for outdoor use (IP66 rated). Installation in a sheltered location
is recommended.
• Battery life will vary based on temperature, settings and number of events.
4.4.2 Installing the Cameras
Follow the instructions below to mount the cameras. It is recommended that you refer to the "In-
stallation Tips" section to help you select good mounting locations (see 4.4.1 Installation Tips,
page 9).
To install your cameras:
1. Set the mounting bracket in the desired mounting position. Mark holes through the mounting
bracket (shown as orange X’s below).
2. Drill holes where marked for the mounting screws using the included drill bit (item C in
toolkit).
#LX400109; r. 5.0/56381/56402; en-US 10
To Next Page
Loading...
Need help?
General