Positioning the camera
13
Positioning the camera
Before you install the camera, carefully plan where and how it will be positioned.
Installation Warnings
• Select a location for the camera that provides a clear view of the area you want to
monitor, which is free from dust, and is not in line-of-sight to a strong light source or
direct sunlight.
• Route the cables so that they are not close to power or telephone lines, transformers,
microwave ovens or other electrical equipment.
• Select a location for the camera that has an ambient temperature between 32°F~113°F
(0°C~45°C); Humidity 20-80% relative humidity (non-condensing)
• If you plan to install the camera in a location that has conditions not recommended in
this manual, consult with a professional installer and consider use of a separate camera
cover or housing
• Before starting permanent installation, have another person hold the camera for you
while you verify its performance by observing the image on a monitor.
Camera Stand Installation
1. Attach the pedestal to the ceiling, wall or other surface by
the base using the provided screws.
2. Attach the camera to the pedestal. Adjust the angle of the
camera, and tighten the thumbscrew to set the position
Night Vision
This camera includes LEDs, which provide the camera with the ability to view images in low light
conditions. It is important to use the provided power adaptor when using the camera for prolonged
periods in low light conditions.
Note: The mounting bracket must be attached to a
structural device such as a wall stud or ceiling rafter
usin
the su
lied screws.
To Next Page
Loading...
Need help?
General
