Additional Information
23
Additional Information
For details on camera maintenance and firmware updates, please refer to the DigiConsole &
DigiViewer Software Manual included on the CD bundled with this package.
Focusing the camera
You can manually adjust the focus of the LNE3003 Remote Surveillance Camera.
Note: Make sure the camera is powered on and connected to a network before
attempting to adjust the focus.
To adjust the focus:
1. Open DigiViewer in your default browser.
Note: You can open DigiViewer from DigiConsole or directly in your browser using your
camera’s IP address.
2. Using DigiViewer as a monitor, turn the silver ring at the lens of the camera back and
forth until image is sharp.
Figure 8.0 Turn the ring back and forth to adjust the focus
To Next Page
Loading...
