6 Controlling the PTZ camera with LNR / NR Series NVRs
To run a pattern:
• Under No., select the number of the pattern you would like to go to
and click
.
NOTE
• We recommend you do not make the camera pan more than
270° between any two points in a pattern.
• For instructions on how to control the PTZ camera using the
smartphone or tablet app, refer to your NVR's instructional
manual.
6.2.4 Auto Scan
An auto scan automatically cycles between a left and right point.
To create a new auto scan:
1. Click
to open the PAN/TILT/ZOOM menu.
2. Click the Border tab.
3. Move the camera into the desired left position and click Left.
4. Move the camera into the desired right position and click Right.
To run an auto scan:
#; r. 4.0/47037/47040; en-US 26
To Next Page
Loading...
Need help?
General
