3
2 Twist the antenna clockwise onto the antenna port on the side of the camera.
3 Attach the camera to the mounting stand. Adjust the angle of the camera until the desired
view is set. Tighten the thumbscrews to secure the desired camera position.
Connect camera stand
Tighten thumb
screws
4 Connect the black power cable extending from the camera to the cable of the power adapter,
and plug in the power adapter to an outlet or surge protector. Make sure the power
connector is fully pushed in to avoid water getting in the plug.
5 Remove the protective film from the front of the camera. If the film is not removed, it will
bl
ock the built-in microphone and potentially affect the quality of the picture.
Peel protective film off
camera
To Next Page
Loading...
Need help?
General
