WARNING
If an owner elects to use the Evora on a closed circuit track or
in a competitive manner, the severity of operating conditions
demands that appropriate levels of expert car preparation,
servicing (over and above that specified in the Maintenance
Schedule) and vigilance will be required, including careful
inspection of all safety critical components both before and
after any track or competition session.
Engine Cover
CAUTION
The engine cover lid may become hot to touch in high ambient
temperatures and/or after hard driving. Allow the car to cool,
or wear appropriate protective clothing before attempting to
access the engine bay.
The composite engine cover is secured by two spigots at the
front edge, and two latches at the rear. To remove the cover, press
the small front buttons on each of the two latches to allow the
latch handles to spring open and release. Lift the rear of the cover
clear of the engine bay surround and draw the cover rearwards
to disengage the front spigots. Place the cover safely aside.
To refit the cover, engage the two front spigots into their loca-
tion eyes on the crossbar, and lower the rear of the cover. Press
down the two handles ensuring that the latch levers are engaged
beneath the rear edge of the engine bay surround, until both
handles are captured by the locking buttons.
Servicing & Maintenance
To Next Page
Loading...
