Steering Column Lever Switches
Lever switches are provided on the steering column, one on
the left for turn indicators and headlamp functions, and one on
the right for windscreen wiping and washing.
Turn Indicators/Headlamp Flash/Dipswitch
Turn Indicators: The turn indicators operate only with the ignition
switched on. Move the lever down to indicate a left hand turn,
and up for a right turn. The switch will be cancelled when the
steering wheel is returned to the straight ahead position.
For convenience, when signalling a lane change, lightly press-
ing the switch up or down will allow its return under spring ac-
tion. Pressing the switch for less than a second will trigger three
flashes of the indicators.
Headlamps: The left hand lever switch is operated by pulling the
lever towards the steering wheel, to one of two spring loaded
positions, and then releasing.
Headlamp Flash: To flash the headlamp high beams with or
withoutignition,pulltheleverswitchtotherstposition;the
high beams will light until the lever is released.
Low/High Beam Switching: When the headlamp switch is pressed
(see page 70), the headlamps will switch on in either low or high
beam mode according to the last made selection. To change
from one to the other, pull the lever fully towards the steering
wheel to the second spring loaded position, and then release.
Each such action will cause alternate selection of low and high
beams. Note that with ignition on, the high beam tell tale in the
instrument panel will indicate the current status.
Instruments & Switches
To Next Page
Loading...
