placed.
- Using adaptor tool T000T1441F, torque tighten the cap to 25
Nm. Check that there is no clearance between cap and hous-
ing.
- Lubricate the small ‘O’ ring supplied with the new filter with
engine oil, and fit into the groove in the filter housing. Fit the
filter drain plug and tighten to 13 Nm.
- Check the oil level (see above) before starting the engine
and restricting to idle speed until the oil pressure tell tale is
extinguished. Check for oil leaks with the engine running.
Stop the engine when fully warm and re-check oil level (see
above).
Servicing & Maintenance
To Next Page
Loading...
