Note; The system cannot be activated below 30 mph (45 km/h) or
above 130 mph (210 km/h), or in first or second gear.
Deactivation: Cruise control will be deactivated when any of the
following actions occur:
- Thebrakepedalisdepressed;
- The clutch pedal is depressed.
- The on/off/cancel button is pressed.
In any of these cases, normal manual speed control will be
restored, but the system will remain enabled.
Resume: To resume cruise, press the resume switch. The vehicle
speed will automatically adjust to the cruise setting.
Changing the cruise setting: Whilst cruise is active, the speed
setting can be adjusted by holding down the ‘+’ or ‘-’ buttons to
accelerate or slow the car to the desired new speed. On release
of the button, that speed will then be set. Alternatively, a single
short press of either button will increase or decrease the setting
by 1 mph (1.5 km/h).
If the system is not active, the car can be driven to the desired
speed, and the set button pressed.
To disable cruise control:Toswitchoffthesystem;withcruise
inactive,presstheon/offswitch;thetelltalelampwillbeextin-
guished. After switching off the ignition, cruise control will be
de-selected for the next drive cycle.
Cruise Control
To Next Page
Loading...
