Safety Precautions
Proper use of folded roll bar and safety belt
1. If tractor has folded roll bar, keep it in ful
ly expansion or in lockup positions. If tractor is operating with roll
bar in folded position, be careful of driving tractor. If the roll bar is in folded position, do not use seat belt.
2. If the tractor restores to normal operating conditions, lift roll
bar to fully expansion position and fasten it
immediately. When roll bar is in fully expansion or lockup position, the safety belt must be used.
3. If spare fastener, retaining ring or retractor is available, the safety belt must be replaced on the whole.
4. Reg
ular check safety belt and assembly fasteners to see whether those fasteners are slack, or safety belt is
damaged or not, such as incision, scratch, abnormal damage and wear etc.
5. If there is no any roll bar or cab on the tractor, do not use safety belt..
Warning!
1.
For safety and security of your life and property, operate the machine in a secure way to bring happiness to
your relative.
2. When the tractor startup, you should note whether there is obstacle on the road or not and if someone stands
between tractor and agriculture implement or trailer, press whistle for warning others to prevent accident
injury due to suddenly startup of the tractor.
3. Do not start and operate tractor at the places away from driver’s seat. When starting tractor, make sure gear
lever is changed to neutral position, power output control stick and front drive joystick disengaged, control
stick for lifter in neutral position, in order to prevent accident caused by suddenly startup of tractor.
4. Do not use jumper s
hort circuit terminal start engine. Otherwise, when the gearbox shifts to the gear, the
tractor will automatically drive out of control. This can cause the accident hazards.
5. The movement of all the pedals shall not be hindered. All the pedals can restore to the original places
smoothly. Never place some obstacles between floor and pedal. Do not place items which can be rolling or
sliding down when stepping down the pedal. No carpets or other matting materials around pedal to avoid
accident due to pedal movement.
6.
Prohibit anyone to get on or off tractor while the tractor is driving, or crawl under the tractor body for
overhaul when engine is in operation, as this can cause personal injury.
7. After stopping, the driver shall pull out the key, move the
gear lever to neutral position and lock up the
parking brake handle before he or she gets off the tractor, in order to prevent accident due to auto-movement
out of control.
8. During transportation, left and right brake pedals shall be interlocked together, control appropriate speed. Pay
full attention to whether it is beyond the height limit or not when driving through culverts and bridges. Slow
down the speed in advance when turning around to avoid unexpected accident, such as rollover, collision.
9. D
uring uphill or downhill, change to the lowest gear, and use throttle control reasonably. The tractor is
inhibited to engage neutral gear or depress clutch pedal to slide down hill. No change of gear allowed when
uphill or downhill to avoid rollover risk.
10. Do not take sharp turn when driving at higher speed or use unilateral brake to take sharp turn, in order to
prevent rollover risk.
11.
When driving on the road, you should pay attention to traffic marks, and strictly follow the traffic rules, in
order to mitigate the risk of accidents.
12.
When driving, you should strictly follow the traffic rules. The space between two vehicles shall be
maintained no less than 60m to mitigate the risk of accident collision.
13. As the embankment near ditch, cave and
dam is more unsecured, the weight of tractor may make it collapse.
Make a detour, or this can run the risk of accidents.
6
To Next Page
Loading...
