Safety Precautions
14. The tractor shall never be overloaded, and is prohibited to work at the extreme limit in order to avoid
personal injury or damage due to overload.
15. When the tractor is working at night, it is essential to set up a good lighting equipment in order to alleviate
influence on performance of tractor and avoid the occurrence of dangerous accident.
16. When the tractor is working on har
vest or yard field, it is required to install spark quench on exhaust pipe to
mitigate the risk of unexpected accident.
17. In the case of rain or snow weather, slow down operating speed in order to alleviate the risk of rollover event
due to slippery ground.
18.
In the case of power output operation, it is a must to make sure reliable connection and protection to prevent
injury caused by separation of moving parts.
19. When linkage or traction of implement, all axle pins shall be connected in a secure way to alleviate collision
risk due to their separation from tractor. While disconnecting or towing implement, make sure all axle pines
separate from tractor to avoid personal injury or machine damage due to unclear separation.
20. When lifting up, pay attention to engine throttle control in order to avoid injury or machine damage due to
overtop.
21.
On charging battery, it is necessary to make sure smooth filler plug vent, far away from open flames. Turn off
the power before the battery is fully charged to prevent explosion.
22.
Keep safety height consistent with the value allowed for high voltage output lines to avoid unexpected
accident!
23.
When tractor is working at field harvest, threshing or transportation for flammable goods, the fire
extinguisher shall be equipped on the tractor to prevent the occurrence of accident.
24.
On transportation of tractor, the user should install fault warning sign plate. If tractor fails to operation and
needs repairing service, the fault warning sign plate shall be put in
the position of more than 30m from aft
tractor, which is used for remain other drivers that there is a vehicle to be repaired on the road ahead so as to
avoid accidents.
Notice:
1. Regular check all bolts, nuts and loose parts on front and rear drive wheels and steering tie rod, if loosening,
tighten them in time to prevent unexpected accidents.
2.
When tractor PTO shaft is working, the housing must be installed for PTO shaft. It is prohibited for
personnel to close to PTO shaft. When it bears load, th
e tractor shall not take a sharp turn to prevent
universal joint or PTO shaft from damage; when PTO shaft is unused, the handle shall be separated from it to
avoid unexpected accident.
3. After stopping, the driver shall not leave the tractor prior to shut
off of the engine in order to prevent
unexpected accident caused by suddenly startup of tractor out of control.
4.
When the tractor has to be stopped on the slope, the hand brake stick shall be in the position for operation,
shut off engine, and engage th
e gear (forward gear in uphill position and reverse gear in downhill position).
Be sure of using parking brake and chocking up rear wheel with triangular plug block to prevent unexpected
accident due to self movement out of control.
5. Tire installation
and adjustment shall be performed by qualified and experienced professionals with
appropriate special tools. Improper installation of tire can cause severe accidents.
6. On cleaning up water tank, turn off the engine, and then start to work until the water tank cools down. This
can prevent scalding injury and damage to the tank.
7.
Before installation of optional parts, new parts or articulated implements, you shall read through instruction
for safety mark and the user manual carefully.
7
To Next Page
Loading...
