Safety Precautions
Important:
1. New ex-
factory or overhauled tractor shall be grinded as required of tractor specification so that the normal
lifecycle of tractor can be guaranteed.
2. The tractor shall be required to use various solutions. Only if the fuel has finished sedimentation for impurity
for least 48h and lubricating oil for power train has filtered by oil filter whose precision is consistent with
lifter suction filter, can filling work be carried out. This can guarantee the life of related parts and working
effectiveness of tractor.
3.
Prior to startup of tractor, be sure of check oil line, circuit and the cooling water; after startup, observe the
reads of all meters and normal operation of tractor.
4. Before the agriculture implement will be driven by using PTO shaft, check if f
itness between tractor and
driven implement is reasonable. In the case of plough, the angle between PTO shaft and universal joint is less
than 15°; with normal hydraulic control, the angle between PTO shaft or implement input shaft and drive
shaft is not greater than 20°after implement is lifted for steering on the edges of field; Never take rotary tiller
into soil till the power output is connected as this can cause severe damage to rotary tiller and clutch of
tractor [in order to improve operation efficie
ncy, power source shall not be cut off when steering. However,
the lifting height of implement from ground shall be 200mm or so].
5. When the temperature drops to the degree below 0℃
in winter, you must use antifreeze liquid in order to
prevent damage of major parts such as water tank and engine.
6.
The front drive axle of tractor is only used in agriculture field work and when the road is muddy to prevent
the tire skid; In other cases, it is disabled, or it is easy to cause early wearing for tires and drive train.
7.
In the process of driving tractor, the driver is not allowed to step on brake pedal or clutch pedal, in order to
mitigate early wearing of brake or clutch.
8. The tractor equipped with agriculture implement moves forward on the road, adjust top
link of suspension
device to shortest status, and regular limited rod to prevent implement swing from side to side. While
tightening locknuts on the top link and limited rod to ensure driving safety and alleviate the risk of machines
and implement damage.
9.
If the implement articulated to the tract displaces, lock it up tightly; Descend the implement onto the ground
before the driver leave tractor in order to mitigate the risk of machine and implement damage.
10. During maintenance, it is essential to sel
ect eligible parts and components in order to ensure the normal
service life of tractor.
Unscrew radiator cap
When the engine is still hot, be careful of unscrew the
Operating for several minutes, deactivate the engine, and then loose radiator
cap to the first gear. Afterwards unscrew the cap until the pressure is released.
Fig. 1-14 Unscrew radiator cap
8
To Next Page
Loading...
