Safety Precautions
When repairing electric parts
1.
Pull out the key for the electric lock switch.
2. Cut off the main power switch for the batter
y before electrical appliance
maintenance.
3.
When repairing tractor by electric welding, it is necessary to disconnect
ground wire from battery and unplug large connector from engine,
hydraulic part computer controller (if equipped), or it is easy to cause
damage of battery, controller and instrument cluster.
Fig. 1-15 Repair of electric
parts
In the case of tractor abnormities
1.
Do not allow tractor to work with “sick”, particularly in the cases of free
or super-low oil pressure, overtop water temperature or unusual noise and
odor, immediately stop for check and troubleshoot problems.
2.
During lubricating maintenance and field adjustment, deactivate the
engine.
Fig. 1-16 In the case of tractor
abnormities
Allowed hoisting position in the front;
Fig. 1-17 Hoisting symbol of
tractor
Safety rules when the tractor is unattended
1. Shift to neutral gear and place hydraulic control stick to neutral position.
2. Descend lifter or tow articulated device onto the lowest position.
3. Engage parking brake.
4. Remove engine ignition key from dashboard.
5. Choke up rear wheel with triangular plug block if stopping on the slope.
9
To Next Page
Loading...
