Operation Instruction
3. Final drive
gives abnormal
noise.
(1) Bearing, gear or shaft is damaged. (1) Replace bearing, gear or shaft.
4.Braking fade
(1) Free travel of brake pedal is excessive.
(2)
Brake pads are excessively or
eccentrically worn out.
(3) Free travel of brake pedal is excessive.
（4）Brake pad is polluted by oil
(1) Readjust the free travel of pedal
(2) Replace brake pads
(3) Readjust the free travel of pedal to
specification
（4）Wash with gasoline and remove oil leak
5. Brake is hot (1) Brake pads do not return.
(2) the brake pedal fails in returning
（3）Small free path of brake pedal
(1) Replace return spring
(2) Adjusting to specification
(3) Adjusting to specification
6. When
braking, the
tractor offset
occurs.
(1) Free travels of left and right brake
pedals are not the same.
(2) Brake friction plate of one side is worn
or polluted by oil
(3) The front and rear tire pressures are not
consistent.
(1) Adjustment
(2) Change or wash the friction plate and
remove oil leak.
(3) Check and inflate it to specified pressure.
3.16.1.4 Traveling system failure and troubleshooting
Table 3-6 Traveling system failure and troubleshooting
Index: Failure Cause Troubleshooting
1.
seriously worn out.
(1) Front wheel rim or spoke is seriously
distorted.
(2) Toe-in is not well adjusted.
(3) Steering knuckle and two clevis pins
with heads of cylinder are severely
worn out.
(4) Tire inflation is insufficient during
transportation.
(5) Front drive axle is not disengaged
during transportation.
(6) Front drive wheel tire tread is
reversely installed.
(1) Correct front wheel rim or
spoke.
(2) Adjust the toe-in
(3) Replace clevis pins with heads.
(4) Check and inflate it to specified
pressure.
(5) Release front drive axle
(6) Readjust the wheel to
specification.
2
swing.
(1) Fixing nuts and bolts attaching ball
pin, cylinder and steering rocker are
loose.
(2) Toe-in is not well adjusted.
(3) Bearing clearance is excessive or
severely worn out.
(4) Front wheel rim is seriously distorted.
(1) Check and tighten it.
(2) Adjust the toe-in
(3) Check or replace bearing.
(4) Correct front wheel rim.
9
To Next Page
Loading...
