Lovol TE304 - Page 54

Index: Failure Cause Troubleshooting
3
The engine
is already
started, but
starter
motor is
till
running,
giving
sharp
noise.
(1)
Copper contact disc is stuck with the
two contact points in the starter motor
relay.
(2) Starter motor lever is released out of
hook or eccentric screw is loose.
(3) Lever return spring is broken or loss of
elastic force.
(4)
Starter motor armature is broken or
bent.
(5) The gear is stuck by galling
(6) The contact point of starting relay is
stuck.
(7) After starting, the ignition switch does
not reset.
(1) Check circuit and rep
air contact
points.
(2) Readjust and fix it.
(3) Replace spring
(4) Repair starter motor
(5) Smooth gear face
(6) Replace starter motor
(7) Replace the ignition switch.