LS Industrial Systems GIPAM - Page 112

56
;AD7!===IgYfAUbiU`
OP CODE Meaning DATA TYPE ADDRESS Description
7 : local on
6 : local off
5 : remote on
4 : remote off
3,2 : 0
1 : on Input
0 : off Input
* LOCAL CLEAR BYTE 33146(H)
BIT Operation
(Higher 1 BYTE)
7,6 : 1
5 : Vo max
4 : CB ON time
3 : CB ON counter
2 : SOE buffer
1 : varh
0 : wh
* REMOTE CLEAR BYTE 33146(L)
BIT Operation
(Lower 1 BYTE)
7,6 : 1
5 : Vo max
4 : CB ON time
3 : CB ON counter
2 : SOE buffer
1 : varh
0 : wh
05h
SOE DATA Remove
3401 Control Command
* Command for requesting the next data after removing the present data in SOE buffer with
single query is not supported
04h
Measurement Part
SETTING DATA Query
Setting CT Ratio BYTE 33201 Lower 1 BYTE
Setting PT Ratio BYTE 33202 Lower 1 BYTE
Setting System Wiring BYTE 33203 Lower 1 BYTE
Setting Relay Enable BYTE 33204 Lower 1 BYTE
CB Operation Count INTEGER 33205
CB Run Time(SEC) INTEGER 33206
CB Run Time(1000h) BYTE 33207 Lower 1 BYTE
04h
OCR/OCGR SETTING
DATA
Operating Current Value
in Time Delay char. of
BCD 33221(H)
X.X
(Higher 1 BYTE)