LS Industrial Systems GIPAM - Page 91

35
;AD7!===IgYfAUbiU`
11.1.6 Phase Voltage
- Requesting Phase Voltage Information
Command 15h
Sub Command -
- Phase Voltage Data
Command 05h
MSB (Byte 3)
Byte 2
Byte 1
R Phase Voltage (R-N)
LSB (Byte 0)
MSB (Byte 3)
Byte 2
Byte 1
S Phase Voltage (S-N)
LSB (Byte 0)
MSB (Byte 3)
Byte 2
Byte 1
T Phase Voltage (T-N)
LSB (Byte 0)
Data Check Sum Check Sum
- The representation follows IEEE Standards (4 Byte Floating Point Number)
- This is available only if “ 3P4W” is set
- Checksum(1Byte) = (Command 1Byte + Data 12Byte) / 256 ⇒ The residual
※ Checksum is the sum of each bytes not to include OVERFLOW.
11.1.7 Zero Phase Voltage
- Requesting Zero Phase Voltage Information
Command 16h
Sub Command -
- Zero Phase Voltage Data
Command 06h
MSB (Byte 3)
Byte 2
V0
Byte 1