LS Industrial Systems GIPAM - Page 92

36
;AD7!===IgYfAUbiU`
LSB (Byte 0)
MSB (Byte 3)
Byte 2
Byte 1
Vo max.
LSB (Byte 0)
Data Check Sum Check Sum
- This is supported only if OVGR enables.
- The representation follows IEEE Standards (4 Byte Floating Point Number)
- Checksum(1Byte) = (Command 1Byte + Data 8Byte) / 256 ⇒ The residual
※ Checksum is the sum of each bytes not to include OVERFLOW.
11.1.8 SOE Data
GIPAM-115N does not respond to requesting data which is related to SOE
function or responds “ NAK Message” .
- Requesting SOE Data
Command 19h
Sub Command 0 0 0 0 0 0 Clear Req.
- Req. Bit : Requesting Data Frame 1
- Clear Bit : Canceling one frame of the data in Buffer at present
a) Requesting the data in Buffer
Command 19h
SubCommand 01h
b) Canceling one frame of the data in Buffer
Command 19h
SubCommand 02h
c) Requesting the next data after canceling the present data in buffer
Command 19h
Sub Command 03h
- SOE Data
Command 09h
Sub Command
00 : SOE Buffer Empty
01 : Information of occurring Fault
02 : Information of setting Relays
03 : Information of CB status / Clearing Data