LSIS Master-K K200S - Page 231

Appendix MASTER-K
A-6
A.2.2 Flags related to the high speed link
The following table shows the flags when the m is 0.
x : K200S/300S = 4, K1000S = 9
m : the number of high speed link setting
Keyword
Bit
Address
Name Description
_HSmRLINK Dx600.0
High speed link
normal run
information(RUN_LIN
K)
Indicates that all stations are normally
operating complying with the parameter set in
the high speed link. This flag turns on under
the following conditions.
1. All stations set in the parameter are in the
RUN mode and have no error, and
2. All blocks set in the parameter normally
communicate, and
3. The parameters set in all stations, which are
set in the parameter, normally communicate.
Once this flag is turned on, it maintains that
state as long as link disable does not make
that state stopped.
_HSmLTRBL Dx600.1
High speed link
trouble abnormal run
information
This flag turns on when, under the condition
that _HSmRLINK is turned on,
communications of the stations and data
blocks set in the parameter is under the
following conditions.
1. A station set in the parameter is not in the
RUN mode, or
2. A station set in the parameter has an error,
or
3. The communications of data blocks set in
the parameter does not normally operate.
This flag turns on if the above conditions 1), 2)
and 3) occur. If normal conditions are restored,
it will turn off again.
_HSmSTATE[k]
(k = 0 to 63)
Dx601.0
to
Dx604.15
Overall
commu nications state
information of K Data
Block set by the high
link parameter
Indicates overall communications state of
every blocks of the parameters set.
_HSmSTATE[k] = _HSmMOD[k] &
_HSmTRX[k] & _HSmERR[k]
_HSmMOD[k]
(k = 0 to 63)
Dx605.0
to
Dx608.15
K Data Block setting
stations mode
information. (RUN =
1, others =-0)
Indicates the operation modes of stations set
the K data block of parameters.
_HSmTRX[k]
(k = 0 to 63)
Dx609.0
to
Dx612.15
K Data Block
communications state
information (Normal =
1, abnormal = 0)
Indicates whether communications of the K
data block of parameters are normally
operating as set .
_HSmERR[k]
(k = 0 to 63)
Dx613.0
to
Dx616.15
K Data Block setting
stations state
information. (Normal
= 1, abnormal = 0)
Indicates whether the stations set in the K data
block of parameters have an error.