Appendix 1 Flag List
App. 1-7
(2) High-speed Link2
High-speed link parameter 2 normal operation of all station.
Indicates normal operation of all station according to parameter set in
High-speed link and On under the condition as below.
1. In case that all station set in parameter is Run mode and no error
2. All data block set in parameter is communicated and
3.The parameter set in each station itself is communicated normally.
Once RUN_LINK is On, it keeps On unless stopped by LINK_DISABLE.
Abnormal state after _HS2RLINK On.
In the state of _HSmRLINK flag On, if communication state of the station
set in the parameter and data block is as follows, this flag shall be On.
1. In case that the station set in the parameter is not RUN mode, or
2. There is an error in the station set in the parameter, or
3. The communication state of data block set in the parameter is not
good.
LINK TROUBLE shall be On if the above 1, 2 & 3 conditions occur, and
if the condition return to the normal state, it shall be OFF again.
_HS2_STATE[k]
(k = 00~63)
High speed link parameter 1, k block general state.
Indicates the general state of communication information for each data
block of setting parameter.
_HS2_STATE[k]=HS2MOD[k]&_HS2TRX[k]&(~_HS2_ERR[k])
High speed link parameter 1, k block station RUN operation mode.
Indicates operation mode of station set in k data block of parameter.
Normal communication with High speed link parameter 1, K block
station.
Indicates if communication state of K data of parameter is
communicated smoothly according to the setting.
High speed link parameter 1, K block station operation error mode.
Indicates if the error occurs in the communication state of k data block of
parameter.
High speed link parameter 1, K block setting.
Indicates whether or not to set k data block of parameter.
To Next Page
Loading...