Chapter 5 Program Configuration and Operation Method
5- 36
(2) Data latch area operation
(a) The method to delete the latched data is as below.
- latch 1, latch 2 clear operation by XG5000
- write by Program (initialization program recommended)
- write „0‟ FILL from XG5000 monitor mode.
For keep or reset (clear) operation of latch area data according to PLC operation, please refer to the
below table.
SRAM broken by battery error
Data broken by other reason
(b) Latch 1 area is cleared by『Online』-『Reset PLC』- “Overall reset”.
To Next Page
Loading...
