LSIS XGK-CPUU - Program Example 2

Chapter 10 Built-in PID Functions
10 - 33
The above graph shows a water level waveform obtained by setting _PIDn_HYS_val too small (10 in
the figure). If a rectangular waveform does not appear 3 times in MV, a correct AT operation cannot be
guranteed. Setting _PIDn_HYS_val too large may cause system slowdown.
10.7.5 Program example 2
The following figure shows the screen of the PID constant value and SV value settings in the 10.7.2
program that performs PID control using the A/D and D/A conversion modules.