LSIS XGK-CPUU - Error Code of Program Operation

Chapter 14 Troubleshooting
14-15
14.5.2 Error Code of Program Operation
Code Error CPU Status Causes Measure
16
Indirect
designation/
Index error
Designations are out of range Designate within the
range
17
Group
command
range setting
error
Designations are out of range Designate within the
range
18
0 divider error Divided by 0 (except RDIV,
LDIV)
Don’t divide by 0
19
BCD
conversion
error
The value of the operand is out
of the BCD data range.
Designate within the
BCD data range
20
File bank
setting error
Bank set value is out of range Set the value within the
range
21
Floating point
operation
error
Floating point operation error Correct the data
22
Data type
conversion
error
Data size is different when
converting from real to integer
numbers
Correct the data
23
BMOV error Set value is over than 16 Correct the set value
24
DECO/ENCO
error
Set value is over than 8 Correct the set value
25
DIS/UNI error The value of N is over 4 Correct the N value
26
Data control
error
Over the range Correct the range
27
Time data
error
Time data error Correct the time data
28 MUX error Set value error Correct the set value
29
Data table
error
Set value error Correct the set value
30
SEG error Number of conversion data is
greater than 4
Correct the set value
31
ASCII code
error
ASCII data error Correct the data
32
Positioning
axes setting
error
Setting axes greater than 3 Correct the number of
axes
33
Character
string error
Character string instruction
error
Correct the instruction
34
SORT error SORT/DSORT instruction error Correct the set value
35
FOR nesting
error
The number of nesting number
is over 16
Correct the program
36
Task number
error
The Task number exceeds 96 Correct the task number
37
Device range
check error
Out of the device range Set within the device
range
38
P2P data
error
A
ccording to the
Basic Parameter
Settings, the CPU
will Run or Stop.
Settings of P2P are out of
range
Set within the range