Chapter 4 CPU Module
4- 5
No. Names Description
④
Reset/ D.Clear
switch
You can enable/disable Reset/D.Clear switch in “XG5000 Æ Basic Parameter
Æ Basic Operation Setup”
1. When Reset switch is enabled
Operation Result
move to left Æ return to center Reset
move to left Æ keep 3 seconds or
above Æ return to center
Overall reset
2. When D.Clear switch is enabled
Operation Result
move to right Æ return to center: General data area and retain area
(M, Automatic variable) will be
cleared.
move to left Æ keep 3 seconds or
above Æ return to center:
General data area, retain area (M,
Automatic variable) and R area will
be cleared.
y Note: DATA CLEAR acts only in “STOP” operation mode.
⑤
USB connector
A connector to connect with peripherals (XG5000 etc.) (USB 1.1 support)
⑥
RS−232C connector
A connector to connect with peripherals
y XG5000 connection: support basically
y Modbus equipment connection: Modbus protocol support
TX: no.7 Pin, RX: no.8 Pin, GND: no.5 Pin
⑦
Battery built-in
cover
Back-up battery built-in cover
To Next Page
Loading...