Lucent Technologies MERLIN LEGEND Release 6.1 System Programming And Maintenance

MERLIN LEGEND Communications System Release 6.1
System Programming and Maintenance (SPM)
555-661-140
Issue 1
August 1998
Programming with SPM
Page 7
Installing the SPM Software
When the installation is finished, the following message appears:
SPM HARD DISK INSTALLATION IS NOW COMPLETE
YOU MUST REBOOT YOUR SYSTEM BEFORE USING SPM
!Remove the SPM diskette from Drive A and reboot your system.
The installation procedure is complete. Go to “Initializing the SPM
Software.”
DOS Installation with Windows 95
Using DOS SPM with Windows 95 improves the interaction of SPM with
the operating system as compared to Windows 3.x installation. For
example, the interaction with the print driver is improved. If an online
printer is not available when you try to print while using SPM, you see a
message box explaining the problem. You can correct the problem by
bringing the printer on-line and continuing, or you can cancel the print
operation. SPM operation is not affected by the error message or the
action you take to correct the problem.
Use the following procedure to install SPM. You do not need to remove
the current SPM files. The new files automatically overwrite your current
SPM files.
NOTE:
This procedure is for installing the DOS version of SPM to run with
Windows 95. Do not use this procedure if you have the Win SPM
application. For Win SPM, refer to the documentation that was
provided with the application.
Considerations
Review the following items before you begin the installation procedure.
The installation program automatically performs the following:

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English