MERLIN LEGEND Communications System Release 6.1
System Programming and Maintenance (SPM)
555-661-140
Issue 1
August 1998
Programming with SPM
Page 8
Installing the SPM Software
■ If you typed LQVWDOO (the command for DOS installation) instead
of
LQVWDO, checks if your PC has Windows 95 installed. If
Windows 95 is detected, you see an error message that tells you
to run the Instal95 program.
■ Creates the directory c:\spm if it does not already exist.
■ Checks if the print.exe file is present in any directory listed in the
PATH environment variable.
■ Runs the DOS SETVER command to set the version table for
print.exe to 6.22. This is required to enable print.exe to run on
Windows 95.
■ Creates an spm.bat file in the directory c:\spm. The spm.bat file
contains the ams_path and print statements required to run SPM.
■ Unzips and copies the remaining files into the directory c:\spm.
■ Instructs you to refer to this document for details on using the PIF
Editor to configure an SPM PIF file to work with the spm.exe file.
Installation
With Windows 95 running on your PC, follow these steps to install SPM
on the PC’s hard disk:
1. Insert the SPM installation disk in any floppy disk drive (usually
the A drive).
2. Choose
one
of the following two methods to install SPM:
Method 1 – Install DOS SPM with French, Spanish, or English
Language:
a. Open a DOS Window from Windows Explorer.
b. At the DOS prompt, switch to the drive with the SPM installation
disk (usually the A drive).
c. At the DOS prompt, type one of the commands shown below and
press
1
.
To Next Page
Loading...
Need help?
General
