MERLIN LEGEND Communications System Release 6.1
System Programming and Maintenance (SPM)
555-661-140
Issue 1
August 1998
Programming with SPM
Page 10
Installing the SPM Software
application will operate properly under this version
of Windows. If you execute this application by
instructing Windows to report a different MS-DOS
version number, you may lose or corrupt data, or cause
system instabilities. In that circumstance, Microsoft
is not responsible for any loss or damage.
Version table successfully updated.
The version change will take effect the next time you
restart your system.
***************************************************
SPM Note: The warning message seen above was produced
by the SETVER command. This command was used in the
SPM install program to set the proper version of
PRINT.EXE file in the DOS version table. Please note
that in Windows 95, running SETVER always produces the
warning message seen above, even when the command is
run properly.
***************************************************
Press any Key to continue . . .
6. Press any key to continue installation. When SPM installation is
complete the following message appears:
Installation of SPM for DOS on your Windows 95 hard
drive is now complete. For easy access to SPM from
Windows 95, configure an SPM.PIF file. See the SPM
Manual for details. Press any key to continue . . .
7. Press any key.
— If you installed DOS SPM using Method 1 in Step 2, close the
DOS Window by typing
exit at the DOS prompt and pressing
1
. If the window does not close, then the Close on Exit
option for the DOS window is not set. In this case, close the
window by clicking on the upper right window icon (the box with an
x in it).
— If you installed DOS SPM using Method 2 in Step 2, the DOS
window closes automatically.
To Next Page
Loading...
Need help?
General
