MERLIN LEGEND Communications System Release 6.1
System Programming and Maintenance (SPM)
555-661-140
Issue 1
August 1998
Programming with SPM
Page 59
Using SPM
SMDR Port Output
See “Printing System Reports” in Chapter 3 of
System Programming
for
more information about the print procedure using the system console
and the SMDR port.
PC Port Output
See “Printing Reports” for more information about the print procedure
using SPM and the PC port.
Restore
The Restore option allows qualified service personnel to load system
programming from either a diskette or from the hard disk into the
processor module memory.
This procedure is used either to program a new system if a disk was
created through surrogate mode programming, or to restore information
(using a backup disk) lost through system failure. It is also part of the
upgrade procedure.
Considerations
Review the following items before you begin the restore procedure.
■ The system will be forced idle during a restore procedure.
■ You must have a backup file containing system programming
before you use this procedure. See “Backup.”
■ Features that were not programmed when the backup file was
created are reset to factory defaults.
■ The data restored reflects the number of extensions and lines
available on the system at the time the backup was created. The
remaining extensions and lines are set to the default values that
are initialized during a Restart (cold start).
■ Restore is terminated under the following conditions:
To Next Page
Loading...
Need help?
General
