Lucent Technologies MERLIN LEGEND Release 6.1 System Programming And Maintenance

MERLIN LEGEND Communications System Release 6.1
System Programming and Maintenance (SPM)
555-661-140
Issue 1
August 1998
Programming with SPM
Page 71
Upgrading the System
■ From Release 4.1 to Release 6.1
■ From Release 4.2 to Release 6.1
■ From Release 5.0 to Release 6.1
■ From Release 6.0 to Release 6.1
MERLIN II Communications System programming cannot be upgraded
to this communications system. The new communications system must
be completely reprogrammed.
Before You Begin
Before you begin the upgrade to Release 6.1, you will need the items
listed below.
■ Any version of SPM to backup system programming information.
■ SPM Version 6.25 or later to convert and restore system
programming information.
NOTE:
If SPM is already installed, the :HOFRPHWR630 screen that appears
when you start SPM identifies the version on both the last line of
the console simulation window and in the upper left corner of the
screen. If you are working with Version 6.25,
9 appears in the
upper left-hand corner of the screen and
9HUVLRQ appears on
the last line of the console simulation window.
NOTE:
The version of SPM packaged with Intuity does not support
conversion. The most current version of SPM is available for
download from NSAC.
■ A processor module with a PCMCIA memory card slot (if one is
not already installed in the system).
■ An R6.1 Forced Installation PCMCIA Memory Card.

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English