Automatic System Answer Lines (#204)—Release 2.0 or
Later
5-31
■ Only outside calls on Automatic System Answer lines are answered
automatically. Intercom, transferred, and transfer-return calls are not
answered automatically.
Valid Entries
1 = Assigned
2 = Not Assigned
✔
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To identify the lines on which outside calls should be answered by the system:
1. Press
f 0 0 s s # 2 0 4.
2. Enter the two-digit system line number of the desired line. For example, to
specify line 1, press
0 1.
3. To assign or unassign the line, press
D until the appropriate value
displays.
4. To identify another line, press
n or p until the line number
shows on the display. Then repeat Step 3.
5. Repeat Steps 3 and 4 for all the lines that you want to identify.
6. Select another procedure or exit programming mode.
To Next Page
Loading...
