Ring on Transfer (#119)
5-235
Ring on Transfer (#119)
Description
This System Programming procedure lets you specify what callers hear while they
are being transferred. If Ring on Transfer is set to Active, callers hear ringing as
they are being transferred; if it is set to Not Active, callers hear silence unless
Music-on-Hold is activated and an audio source is connected to the system. If this
is the case, callers hear music while the call is being transferred to the destination
extension. Once there, callers hear ringing until the call is answered or it is sent to
the voice messaging system.
Related Features
â– If you have an audio source connected to the system, set Music-on-Hold
(#602) to Active and Ring on Transfer to Not Active, so callers hear music
as they are being transferred to the destination extension.
â– This procedure has no effect on Direct Extension Dial or Call Park.
Valid Entries
1 = Active ✔
2 = Not Active
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To change Ring on Transfer:
1. Press
f 0 0 s s # 1 1 9 at extension
10 or 11.
2. Press
D until the appropriate value displays.
3. Select another procedure or exit programming mode.
To Next Page
Loading...
Need help?
General
