Copy Settings (#399)
5-97
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To copy the programmed settings from one extension to another of the same type:
1. Press
f 0 0 s s # 3 9 9 at extension
10 or 11.
2. At the
Extension:
prompt, enter the source extension to copy from. For
example, to copy the current settings from extension 18, press
1 8.
3. At the
Data- - - - - - - - - - - -
prompt, enter the target
extension to copy to—any extension except the source extension is valid.
For example, to copy to extension 22, press
2 2.
4. At this point:
â– To copy the same settings to another extension, enter the new
extension number.
■To copy another extension’s settings, press n or p until
the extension number shows on the display. Repeat Step 3.
5. Select another procedure or exit programming mode.
To Next Page
Loading...
Need help?
General
