Feature Reference
5-164
Intercom Dial Tone (#309)
Description
This System Programming procedure determines the type of dial tone that the
system provides at an extension. It may be necessary to change this setting to
Machine (outside line) dial tone for an autodialing device, such as a fax or
modem, that has trouble making calls. For example, if you have a modem that
checks for outside line dial tone before dialing, use this procedure to change from
Regular to Machine dial tone.
Considerations
Use this procedure
only
if an autodialing device has trouble making calls.
Valid Entries
1 = Regular dial tone ✔
2 = Machine (outside line) dial tone
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To change the Intercom Dial Tone setting for an extension:
1. Press
f 0 0 s s # 3 0 9 at extension
10 or 11.
2. At the Extension: prompt, enter the number of the extension to be
programmed. For example, to select extension 22, press
2 2.
3. To change the Intercom Dial Tone setting, press
D until the
appropriate value displays.
4. To program another extension, press
n or p until the
extension number shows on the display. Then repeat Step 3.
5. Select another procedure or exit programming mode.
To Next Page
Need help?
General
