Hunt Group Extensions (#505)
5-163
To assign extensions to a Hunt Group:
1. Press
f 0 0 s s # 5 0 5 at extension
10 or 11.
2. At the Group: prompt, enter a group number (1–8). For example, to select
group 1, press
1. A display similar to the following appears:
Hunt Group 1
Extension:
3. Enter the desired extension number. For example, to select extension 31,
press
3 1.
4. To assign or unassign the extension, press
D until the appropriate
value displays.
5. At this point:
■ To assign or unassign another extension, press n or p
until the extension number shows on the display. Repeat Step 4.
■ To program another group, press N P, enter a
new group number, and repeat Steps 3 and 4.
6. Select another procedure or exit programming mode.
To Next Page
Loading...
