Group Hunting—Ring/Voice Signal (I77G/I*77G)
5-151
Using
System Phone
To use when programmed on a button:
â– To
ring
or
voice signal
an extension in the Hunt Group, simply lift the
handset or press
S and press the programmed button. If you are voice
signaling, start talking after the beep.
â– To
transfer
a call to an extension in the Hunt Group, while on a call press
the programmed button.
To manually ring or voice signal a Hunt Group:
1. Lift the handset and press
i.
You hear intercom dial tone.
2. To make a
ringing
call, dial 7 7 and a group number (1–8).
The next available extension in the Hunt Group rings. If no one answers
within three rings, the call hunts to the next available extension.
To make a
voice-signaled
call, press * 7 7 and a group number (1–8).
After the beep, start talking.
Your voice is heard through the speaker of the first available system phone
that is not busy. If no one answers, the call does not keep hunting.
To manually transfer a call to a Hunt Group:
1. While on a call, press
&.
2. Dial
7 7 and a group number (1–8).
The next available extension in the Hunt Group rings. If no one answers
within three rings, the call hunts to the next available extension. However, if
Transfer Return Rings is programmed for less than four rings, the call
returns to the extension that transferred the call, or to that extension’s
transfer return extension.
Standard Phone
To ring or voice signal a Hunt Group:
1. Lift the handset.
You hear intercom dial tone.
2. To make a ringing call, dial 7 7 and a group number (1–8).
The next available extension in the Hunt Group rings. If no one answers
within three rings, the call hunts to the next available extension.
To make a voice-signaled call, press * 7 7 and a group number (1–8).
After the beep, start talking.
Your voice is heard through the speaker of the first available system phone
that is not busy. If no one answers, the call does not keep hunting.
To Next Page
Loading...
Need help?
General
