Feature Reference
5-178
Valid Entries
System line number
System extension number
No lines owned by an extension
✔
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To change the Line Coverage setting for an extension:
1. Press
f 0 0 s s # 2 0 8 at extension
10 or 11.
2. Enter the desired line number. For example, to program line 12,
press
1 2.
3. Enter the number of the extension to be assigned ownership of the line.
4. At this point:
■ To delete the current setting, press r.
■ To program another line, press n or p until the line
number shows on the display. Then repeat Step 3.
5. Select another procedure or exit programming mode.
To Next Page
Loading...
