Feature Reference
5-198
Valid Entries
1 = Assigned to next available button at extension 10
2 = Not Assigned
✔
3 = Select Button (then press a programmable button to assign Night Service to
that button)
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To program a Night Service Button at extension 10:
1. Press
f 0 0 s s # 5 0 3 at extension
10.
2. At this point:
â– If you want to assign Night Service to the first available button, press
D until a display similar to the following appears:
Night Service Button
1 Assigned - Ext10
â– If you want to remove the Night Service button assignment, press
D until a display similar to the following appears:
Night Service Button
2 Not Assigned
â– If you want to assign Night Service to a specific button, press 3. A
display similar to the following appears:
Night Service Button
3 Select a Button
Then press a programmable button with lights to assign Night
Service to that button.
3. Select another procedure or exit programming mode.
4. Label the Night Service button at extension 10.
Using
To turn Night Service on:
1. Press the Night Service button at extension 10.
â– If a System Password is programmed, the green light next to the
button flashes; you must continue with Step 2.
â– If no System Password is programmed, the green light is on steady
and Night Service is on.
To Next Page
Loading...
Need help?
General
